Tools you will need:

Small phillips screw driver

Procedure:

1. Remove the small screw on each side of the housing. The housing with the lens should fall off after removing the screws.

2. Remove the old lens. This might just easily fall out. If not, you will have to flex the side of the black plastic housing where the arrows are while lifting up on the lens.

3. Remove the old light bulb by pushing it in and rotating counter clockwise. Then install the new light bulb.

4. Install the new lens by sliding the bottom of the lens into the groove in the housing and pushing the top in place.

5. Install the housing back in to the car by sliding the bottom of the housing into the groove in the bracket on the glass, and then install the 2 screws.